İsviçre
İsviçre

myGeobrugg

Arlberg Mountain Pass - road connection Rauz-Stuben

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

View of Stuben am Arlberg toward the Rauz junction. The new 1.3 km route with 5 bend is visible. To secure the road cut, the experts placed their trust in the TECCO® SYSTEM³

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

A project on a large scale – completed on schedule thanks to the efforts of all those involved and which is also an attractive solution befitting to the Alpine scenery surrounding it

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

A bend under construction: two temporary GBE-500A rockfall barriers with a height of 3.5 m securely catch rocks carried away and left loose following blasting and chiseling work before they reach the lower levels of the "old" Arlbergpassstrasse

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

One of the new rock cuts stabilized with TECCO® SYSTEM³ - visible nails offset and minimal visual impact

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

The bottom border of the TECCO® G65/3 high tensile mesh has been strengthened with a 12 mm border rope guided along the surface above the nail and under the system spike plate P33/40. Every second mesh opening is connected to the border rope with a T2 press claw

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

TECCO® G65/3 high tensile mesh perfectly adapts to the terrain morphology. By placing the spike plate in a lowest points of the surface, certain pretensioning can be applied, minimizing further facing deformations

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

TECCO® SYSTEM³ knotted meshes edges are connected edge to edge without any overlap using T3 clips and without the need for tools. In comparison to conventional solutions where the mesh wires at the edge are only bent, this design enables up to 30 % less mesh to be used

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

It is important that the spike plate's longitudinal axis is horizontally aligned. This is the only way to ensure that the full load can be transmitted from the TECCO® G65/3 mesh to the nail via the system spike plate. If correctly installed, spike plate covers over 16 wires of the mesh, giving the facing very high puncturing restistance

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

Slopes with inclination bigger than 80° are successfully protected against erosion with the TECMAT® erosion control mat beneath the TECCO® SYSTEM. This solution allows vegetation to grow here.

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

Even on very uneven and rough surfaces, TECCO® SYSTEM³ is easy to install. The nails were positioned here so that the spike plate can optimally tension the TECCO® G65/3 mesh

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

Areas secured with TECMAT® (three-dimensional anti-erosion mat made from PP monofilaments) and TECCO® G65/3 mesh in October 2015, saw its first green shoots emerge at the beginning of May 2016. Construction site is 1500 m above sea level and has south-west exposition

Şev ve Yamaç koruma - Arlberg Mountain Pass - road connection Rauz-Stuben 2015

New slopes surfaces are strongly fissured and crushed. In some areas additional snow protection solutions were installed. Here overview of a fully installed TECCO® SYSTEM³

 

Kurulum Yılı

2015

Durum

The Arlbergpassstrasse L197 road connects regions of Tirol and Vorarlberg. At the Rauz junction, the road becomes Lechtalstrasse L198. In winter it provides the only safe connection to the popular winter sports destinations of Lech and Zürs. The management of the Arlbergsstrasse, geographically situated in the right hillside of the Rauzbach river, had until now been subject to constant, extreme rockfalls, rockslides, and slope instabilities.

Jeoloji

Shell limestone and Arlberg formation.

Açıklama

In 2011, a feasibility study was conducted into rerouting the road. In 2014, the Austrian state of Voralberg began the construction of five hairpin bends with a length of 1.3 km and at a cost of around 9 000 000 EUR. The new route loosely follows a rough historic path.

Due to the high slope gradient, the serpentine roadways can only be guided with the appropriate support structures and by following gaps in the terrain. The removal of rocks from around 65 000 m³ of the alpine Muschelkalk (shell limestone) and Arlberg rock formations was mainly carried out using explosives.

The Nüziders subsidiary of civil engineering company HTB installed around 140 m of temporary GBE-500 rockfall protection barriers with an overall height of 3.5 m to enable safe construction and traffic flow. The permanent, active securing, of the newly formed tracks through the terrain using 11 445 m² of TECCO® System as well as measures to protect against erosion and snow slides using around 1680 m² of TECMAT® were also taken care of by HTB.

In October 2015, the new 1.3 km route was approved – on schedule and in accordance with the latest road safety regulations.

Müşteri

Amt der Vorarlberger Landesregierung

Yüklenici

HTB Baugesellschaft mbH

Gösterilen obje

Road

Korozyon koruması

GEOBRUGG SUPERCOATING

Mühendislik

GEOGNOS Bertle Technische Geologie Ziviltechniker GmbH

Kurulan diğer uygulamalar

Kaya düşmesine karşı koruma

Yerel yetkiliniz

Roger Moor
   

Roger Moor

Country Manager Ost- und Zentralschweiz, Liechtenstein

Natural Hazards
Hidrolik mühendisliği
Mining / Tunnels
Geobrugg AG,Aachstrasse 11,8590 Romanshorn / İsviçre Country Manager Ost- und Zentralschweiz, Liechtenstein

e-posta

René Müller
   

René Müller

Country Manager Kantone AG BE BL BS FR GE JU NE SO VD VS

Natural Hazards
Hidrolik mühendisliği
Mining / Tunnels
Geobrugg AG,Industriestrasse 21,5200 Brugg / İsviçre Country Manager Kantone AG BE BL BS FR GE JU NE SO VD VS

e-posta

Alexander Bittendorfer
   

Alexander Bittendorfer

Project Manager Inspection Services

Natural Hazards
Geobrugg AG,Aachstrasse 11,8590 Romanshorn / İsviçre Project Manager Inspection Services

e-posta

Isacco Toffoletto
   

Isacco Toffoletto

Ticino Country Manager

Natural Hazards
Hidrolik mühendisliği
Mining / Tunnels
Geobrugg AG Ticino,Stabile Cometal, via Pizzante 7,6595 Riazzino / İsviçre Ticino Country Manager

e-posta