United States
United States

myGeobrugg

Kaikoura State Highway 1 (SR1-2)

Asset Management / Monitoring - Kaikoura State Highway 1 (SR1-2) 2019

Looking north - 3 m high GBE-500A rockfall barrier

Asset Management / Monitoring - Kaikoura State Highway 1 (SR1-2) 2019

Looking upslope - 50 meters long and 3 meters high GBE-500A rockfall barrier

Asset Management / Monitoring - Kaikoura State Highway 1 (SR1-2) 2019

Looking upslope -support rope separation

Asset Management / Monitoring - Kaikoura State Highway 1 (SR1-2) 2019

Looking north - 3 m high GBE-500A rockfall barrier . Note: downslope anchor for upslope change in direction

Asset Management / Monitoring - Kaikoura State Highway 1 (SR1-2) 2019

Looking south - 3 m high GBE-500A rockfall barrier

Asset Management / Monitoring - Kaikoura State Highway 1 (SR1-2) 2019

Looking North - 3 m high GBE-500A rockfall barrier installed above shotcrete and precast walls. SH1 and the Coastal Pacific rail is an important lifeline and transport route going North from Christchurch.

 
 

Year of installation

2019

Initial situation

The Kaikoura M7.8 earthquake caused widespread damage to the road and rail corridor for approximately 20 km North and South of the Kaikoura township. Over forty major slips inundated the road and rail with more than 750'000 m³ of material from source zones up to 500 meters above sea level.  The highly fractured Grey Wacke means frequent future rockfalls and debris loads. The high rockfall frequency created the requirement for a geohazard solution at Site 1-2.

Description

The original design and installation was a 50 meters long 3 meters high GBE-500A barrier. After installation, the decision was made to install an additional 50 meters of barrier to protect the highway further. The system was easily extended by upgrading the northernmost post to a support rope separation with no material wastage.


The GBA-500A is a hinged post system. The barrier has upslope anchors, which reduce the post foundation forces and therefore minimise impact to the precast concrete wall and shotcrete retaining walls below. The rockfall barrier used a 10 meters post spacing, had two downslope anchors due to a curved alinement and as previously mentioned was split into two sections with a support rope separation. Due to the highly fractured rock mass, self-drilling anchors were required. Geobrugg type II flex heads transfer the loads to the bar anchors. The mesh was ultra-coated due to its proximity to the sea.

Country/Region

New Zealand

Customer

NCTIR and NZTA

Contractor

Rock Control

Protected object

Road

Corrosion protection

GEOBRUGG ULTRACOATING

Your local contact

Saleh Feidi
 

Saleh Feidi

Regional Manager California

Natural Hazards
Impact Protection
Geobrugg North America, LLC,8921 Emperor Ave.,91775 San Gabriel, California / United States Regional Manager California

E-Mail

Bryant Jackson
 

Bryant Jackson

Regional Sales Manager Northeast

Natural Hazards
Impact Protection
Geobrugg North America, LLC,22 Centro Algodones Regional Sales Manager Northeast

E-Mail

John Kalejta
 

John Kalejta

Regional Manager Rocky Mountains / Central USA

Natural Hazards
Impact Protection
Geobrugg North America, LLC,KS 67226 Wichita / United States Regional Manager Rocky Mountains / Central USA

E-Mail

Robert Long
 

Robert Long

Regional Sales Manager Southeast

Natural Hazards
Impact Protection
Geobrugg North America, LLC,24905 Winterberry LN,60585 Plainfield / United States Regional Sales Manager Southeast

E-Mail

Pierce Runnels, Civil Engineer
   

Pierce Runnels

Sales Director North America

Natural Hazards
Geobrugg North America, LLC,22 Centro Algodones , Civil Engineer Sales Director North America

E-Mail

Tim Shevlin
 

Tim Shevlin

Regional Sales Manager Pacific Northwest and Hawaii

Natural Hazards
Impact Protection
Geobrugg North America, LLC,OR 97302 Salem / United States Regional Sales Manager Pacific Northwest and Hawaii

E-Mail